Shed makeover: Day 3

Posted by jerry on December 30th, 2004 — Posted in DIY, Journal, Woodwork

Well, the most expensive part of the makeover so far was today – AU$25.00 for a half sheet of peg-board and about six bucks for some framing timber. I did get some hinges, so I was able to hang the door on the corner cupboard as you can see here;

shed makeover

The next thing I did was to fit a proper woodwork vise to my workbench. The thing is now recessed so that the fixed jaw is in line with the bench. I had to add a packing piece underneath so the whole vise would be flush with the bench top. It was fiddly work and took me about an hour. As you can see, it’s not the world’s neatest job, but it works. The vise is a cheap Chinese import but will do the job. I will eventually add some wooden jaw protectors, but that will be for another time

shed makeover

The reward was going to get some pegboard – Carba-Tec in Fyshwick is selling off some excess pegboard sheets at a discounted price – I picked up a half-sheet (there was no way I could fit a whole sheet in the van!

Anyhow I got the sheet home and cut it to fit between two horizontal frame members of the shed. It is awkward stuff to handle – and to get around the problem of trying to support it with one hand while attaching it with the other, I screwed a small piece of spare pine stock to the lower wall beam to provide a stable base to rest the pegboard on while I attached it at the top. It was then easy to add two more screws to the top and the same at the bottom before removing the temporary support.

I then cut two pieces of 45x19mm pine to length for the upper and lower surrounding frame, then cut two pieces to fit the sides and I added these to the pegboard starting with the bottom and then the two sides and finally the top which then had the side pieces to rest on. Here is the result:

shed makeover

So that’s it for day three of the shed makeover. Tomorrow, being New Year’s Eve I’ll tackle one of the smaller cupboards and paint the doors. And I can start to put my tools away properly. And that will be one end of the shed completed – I dare not turn round because in order to get one end cleaned up, of course I had to move everything to the other end which is now TWICE as cluttered as it was before! It’s like the Cat in the Hat all over again 🙂

But I have a plan for the other end…

Until tomorrow then
Cheers
Jerry

No Comments

No comments yet.

RSS feed for comments on this post.

Sorry, the comment form is closed at this time.