Canberra Working With Wood Show – again

Posted by jerry on September 6th, 2004 — Posted in Journal, Woodwork

Well, Sunday I just had to go back to the Working With Wood show – catching up on the demonstrations I missed the first time around. I always learn heaps at these shows – there was an excellent demonstration on making small wooden boxes, using a router and four cutters.

Outside there was a demonstration of chain saw sculpting – and a bizarre but skillful sculpture emerged of an Islander in an outrigger canoe – an amphibious one!

wood sculpture

And there were the usual displays of portable saw mills, including the mighty Lucas mill – which turned my burnt ribbon gum tree into boards for me after the bushfires last year. But each year there are new innovations, like this one for smaller chainsaws for lifting slabs off lumber where it lies – great for reclaiming timber from dead trees or storm windfalls. This one doesn’t run on rails, but rather rides over the tree trunk while keeping the saw blade parallel throughout the cut. Simple, but effective.

chainsaw mill
This is at the start of the cut

chainsaw mill
and this is near the finish.

The result is a timber slab suitable for a bench seat or coffee table, and the size of the setup is ideal for reclaiming urban trees that are often not so large as forest trees, ones that would otherwise just be chipped when they grow too tall for the telegraph wires.

And yes I did pick up a couple more toys – notably a thread cutter for a wooden embroidery frame that my partner has been dropping subtle hints over…

Cheers
Jerry

No Comments

No comments yet.

RSS feed for comments on this post.

Sorry, the comment form is closed at this time.